Skip to Content
ProCure Manual Firmware Update
Please follow the step-by-step guide below to manually updated your ProCure firmware:
1
Turn off Pro Cure and unplug it from power
Toggle the rear power switch to the off position
Unplug the power cable from the power plug port
Note: the Pro Cure must be disconnected from power to successfully update
2
Connect Pro Cure to your computer with a USB-A to USB-B cable
This must be done only after the machine is disconnected from the power
3
Locate the Pro-Cure in Windows File Explore
To open File Explorer, click on the File Explorer icon located in the taskbar. Alternatively, you can open File Explorer by clicking on the Start button and then clicking on File Explorer or use the keyboard shortcut (WIndows Key + E)
The Pro-Cure will appear as a USB DISK (D:) on your computer
If the Pro-Cure does not appear right away, unplug the USB from your computer, then plug back in
4
Format the Pro-Cure USB drive
Right click on the USB drive location
Select Format
5
Download these two files to your computer
version.txt (4 Bytes)
procure.bin (400 KB)
6
Manually add the following two files to the Pro-Cure USB to replace the previously deleted files
Note the files must appear exactly as is, be sure the files are not URL links but rather files containing actual data
This can be done manually by selecting the files then sending them to the correct location
Files can also be dragged and dropped from quick download bar
7
Properly eject the Pro-Cure USB drive
Utilize the eject function on your computer before physically removing the cable
Right click on the USB drive and select eject
Remove the USB-A to USB-B cable completely from the Pro-Cure
If the cable remains attached to the Pro-Cure the machine will sense a connection and the process may not complete correctly
8
Power on the Pro-Cure
Plug in the power cord
Turn the Pro-Cure power switch to the on position