Drain Port Quick Connect Replacement

Instructions on how to replace a faulty IPA reservoir quick connect for Chamber 1 or 2 on the PWD.

qs_guide_contents.png

Step 1: Drain the Affected IPA Chamber

Using the drain hose attached to the back of the Pro Wash/Dry unit, drain any remaining IPA from the chamber with the faulty drain port

PWD_drain.png

Wipe the area under the faulty drain port to clean any drips of IPA that may have leaked during the cleaning process before proceeding. Take this opportunity to clean any debris or sediment that remains in the affected chamber with the brush included with the Pro Wash/Dry, as well as clean paper towels.

Step 2: Prepare the Drain Port

Open the SprintRay labeled box that includes two replacement drain port quick connects and the wrench required to remove and replace

box_open.png

Remove the protective wrapping for the new drain port, being careful not to damage the white Teflon sealing tape on the threads

new_couper_highlighted.png

Step 3: Remove the Faulty Drain Port

Using the 19 mm end of the wrench, place it on the rear hex nut that is flush against the red plastic the Pro Wash/Dry as pictured below

removing_old_drain.png

Remove the drain port by gently unscrewing in the counter-clockwise direction

loosening_old_drain.png

Once loosened with the wrench, you can unscrew the drain port by hand until completely removed from the unit

old_out.png

If any residual thread seal tape is fraying in the threaded opening, use tweezers to remove

Step 4: Install the New Drain Port by Hand

Before installing, check that there is no damage to the white Teflon sealing tape before installing in the Pro Wash/Dry

new_in.png

Gently screw the new drain port in by rotating clockwise until hand tight

new_tighten.png

Step 5: Tighten Drain Port with Wrench

Once the new drain port cannot be tightened any more by hand, use either the 19mm or the 22mm end of the included wrench on the drain port to tighten completely. If the rear portion of the drain port is difficult to reach with the 19mm end of the wrench, you can use the 22mm end on the larger nut for easier access.

Note: Do not overtighten the drain port, or damage can occur to the IPA chamber

new_tighten_wrench.png

Drain port quick connect should be fully seated once complete

done.png

You can now proceed with normal usage of the Pro Wash/Dry.

We can help with that!

If you're experiencing difficulties or have questions about any of your SprintRay products, submit a support ticket or contact us at 800-914-8004

Was this article helpful?
0 out of 1 found this helpful