Starting a Print with Kickstarter MoonRay

Once your MoonRay is unboxed, set up, and you've installed the latest version of legacy RayWare, you can follow the steps below to begin the printing process. Make sure all parts of your MoonRay are clean before starting a print.

Check that the projector display settings are correct and your computer's screen saver and sleep mode are disabled before starting a print.

Make sure the resin tank and build platform are clean and in the correct positions.

Properly connect the HDMI, USB, and power cables on the back of MoonRay. Turn MoonRay on by pressing the power button, so you see the green ring around the button.

Make sure your computer's screen saver and sleep mode are disabled. If your screen saver turns on or your computer goes into sleep mode while printing, you will need to start your print from the beginning.

1. Launch RayWare.

2. Click the + icon on the top left of the screen to add your model (.STL file). 

3. Add support structure.

4. Print your model.

If you need any assistance, don't hesitate to reach out to us at: 800-914-8004.

 

We can help with that!

If you're experiencing difficulties or have questions about any of your SprintRay products, submit a support ticket or contact us at 800-914-8004

Was this article helpful?
0 out of 0 found this helpful