SprintRay Gray

SprintRay-materials-resins-dental-gray-2.jpg

Our most popular resin, Gray, is a great option for study models, wax ups, and models used in traditional forming processes for aligners and retainers. 

All pigmented resins are prone to separation. It is important that you mix up your resin very well before pouring into the tank, stir before each use, and don't allow the resin to be exposed to air for more than three days. If the resin has been out for less than three days, you can pour it back into the bottle for use later. Resin stored properly is good for up to a year.

Any UV Light source can be used to post cure your gray. With an inexpensive 48W 400-420nm set up you typically get post cured parts in less than 30 minutes. Using professional curing tools with temperature controls, you should get full cure in about 15 minutes at 40C or higher. 

Material Safety Data Sheet

We can help with that!

If you're experiencing difficulties or have questions about any of your SprintRay products, submit a support ticket or contact us at 800-914-8004

Was this article helpful?
0 out of 0 found this helpful