Tools Included with SprintRay Pro

Resin Wiper

The resin wiper is a small, soft, rubber wedge that is designed to mix the resin in your resin tank. Its pliable materials make it ideal for gently dragging across the surface of your tank without damaging or scratching the window. mceclip1.png

Print Removal Tool

This tool is ideal for levering under the edges of your prints where they stick to your build platform. Slowly work around the edges of your print, then apply upward pressure to snap your prints free. Always slide the print removal tool along the surface, never stab or jam the print removal tool as it may cause gouges in your print platform.

mceclip5.png

Support Snipper

The support snipper is akin to wire- or flush-cutters. Use it to cut supports off of your models as closely to the model surface as possible. Supports can often be pulled off by hand, but the support snipper is recommended for important areas for better surface finish.

mceclip2.png

Cleaning Cloth

Essentially just a microfiber cloth. Use the cleaning cloth to clean the hood and screen of the printer. The rest of the printer can be cleaned with a soft cloth or paper towel.

mceclip3.png

Resin Tank

The resin tank should be pre-installed in SprintRay Pro when you take it out of the box. The resin tank holds your liquid resin and should be treated with care. Clean your resin tank with IPA and a soft cloth. Never use anything abrasive to clean your resin tank, as the bottom can easily scratch, compromising your prints. For more information, visit the resin tank maintenance article

mceclip0.png

Print Platform

The print platform should be pre-installed in SprintRay Pro when you take it out of the box. The print platform lowers into your resin tank and raises by 100-25 microns per layer until a model is completed. The platform has a magnetic lock, activated by rotating the red circular switch on the build arm. 

mceclip1.png

Was this article helpful?
1 out of 3 found this helpful