Printing with SprintRay Pro

Once you've set up your print in RayWare, it's time to prepare Pro for your print. 

Ensure Pro is ready

Install resin tank and build platform in their places. Double check that both of these are fully secured and locked before you print.

mceclip0.png

Fill resin to proper level

Fill the resin tank with the desired material up to the level indicated by PrintOS and RayWare. Level indicators are located on the inside of the tank.

mceclip2.png

mceclip1.png

Start the print

Click 'Print' in RayWare. If printing directly from a USB stick, press 'Print' on Pro's touchscreen. The software will process the job (this may take a few minutes), then the build arm will lower. Once the build arm has lowered into the resin and the blue light starts flashing, the job has begun. 

mceclip1.png

We can help with that!

If you're experiencing difficulties or have questions about any of your SprintRay products, submit a support ticket or contact us at 800-914-8004

Was this article helpful?
1 out of 5 found this helpful