Editing Supports

This article focuses on how to edit supports. For a more complete tutorial on how to properly support your models, visit the Supporting a Model page.

Editing Supports

Sometimes, the algorithm that determines where supports should and shouldn't go will add supports where they are obviously not necessary or will leave a small overhang unsupported. To remedy this, click the 'Edit Supports' button at the bottom of the Supports tab. 


To remove an existing support, hover over it with your mouse. An existing support will turn red when you're hovering over it, indicating that it will be deleted if you press the left mouse button.


To add a support, click on the model where you'd like the support to be. RayWare will automatically connect the support to a stable surface, usually the model's base. 

Was this article helpful?
1 out of 4 found this helpful