ProCure 2 Safety

Wear gloves when handling uncured parts

When printed models come out of your 3D printer, they are coated in uncured resin. Wear gloves when handling 3D printing resin, as it is a sensitizer. The wash process makes use of high-concentration IPA, which can sting if it comes into contact with skin.

Once parts are fully post-cured, gloves are no longer necessary as the model is fully stable.


Don't touch, ProCure 2 gets hot

To maintain proper temperature for fast and thorough curing, ProCure 2 includes an onboard convection heater. Do NOT set anything on top of or behind ProCure 2, as these are the ventilation ports. The ProCure 2 can heat up, so be careful when touching the metal surfaces as they may be hot.


Always close the Curing Tray Door Completely

ProCure 2 uses high-intensity, broad-spectrum light in the UV range. The door includes a sensor that will not allow ProCure 2to operate while open. This is for your safety. Do not attempt to open the door while ProCure 2is operating.

Was this article helpful?
0 out of 0 found this helpful