Preparing Monolithic/Try-in Dentures in RayWare Cloud

RayWare Cloud takes the effort out of preparing your Try-In Dentures for print, by automatically nesting them at the most optimal, fully supported angulation.

 

sprintray-tryin-denture.png

 

To begin, select Denture, Try-in, select your Printer type, select No for Auto Mesh Repair, and then select your material type.

 

tryin_selection.png

 

Once you have verified your selections, you can drag and drop your STL files or click Browse to locate them in your file viewer. Select Next.

 

tryin_upload.png

 

RayWare cloud will then analyze your models and place them in their optimal position with
ideal support placement.

Once uploaded, rotate the view to the underside of the model and check the support placement.
For best results, Denture Try-in Models should have adequate supports along the flange, and minimal supports on the intaglio surface for quicker post processing and polishing.

Should you need to add or remove supports, click on the model and select Supports from the right hand menu and select Add/Remove Individual Supports.

 

tryin_support_select.png

 

The blue dots on the model surface indicate where supports will be placed. Click on the model surface to add a support or hover over a blue dot until it turns red and click to remove the support.

 

tryin_edit.gif

 

Once finished, click Confirm Changes, then click Send to Printer. Select your compatible printer, and click the Send to Queue button.

 

tryin_ready.png

We can help with that!

If you're experiencing difficulties or have questions about any of your SprintRay products, submit a support ticket or contact us at 800-914-8004

Was this article helpful?
0 out of 0 found this helpful