Remove Build Platform

When a print job is successfully completed, the build platform will rise to the top of the Z-axis tower. The build platform with the printed part is ready to remove. Have a paper towel ready to catch potential drips of uncured material. 
 

To remove the build platform with printer models:

1. To open the hood, pull the hood lock on the rear side and then lift the hood upwards.
   

   

2. Place one hand on the build platform handle. Loosen the build platform torque knob with the other hand.
   

   

3. Lightly cradle the bottom of the build platform with the paper towel. This will help to prevent dripping while removing the build platform from the printer.
4. Pull the build platform towards yourself until it comes free from the printer.
    

Detach Printed Parts from Build Platform

Once the job is complete, the printed parts hang off the build platform.

1. Place the build platform on its side in the processing zone as shown in the diagram below. Watch the material so it doesn’t leak into the build platform cavity. Ensure the magnet stays clean.
2. Hold the build platform handle with one hand to steady the platform.
3. Use the scraper from the Starter Kit to gently detach printed parts from the build platform. Angle your tool roughly 30 degrees from the platform and move the blade while applying a slight amount of pressure.

   

4. Place each printed part on a paper towel to catch the excess material as it drips.
    

Reset After Print

1. Once the printed parts are removed, use the metal scraper to remove any remnants of the printed job from the surface of the build platform.
2. Wipe the entire platform dry using a paper towel. The previous print job shouldn’t be visible on the platform.
3. Install the build platform on the printer and tighten the build platform torque knob.
   

   

4. Close the hood.