Overview

Before printing with a Multi Unit Capsule, the resin must go through both automated pre-priming on the printer and manual priming using the included priming tool. Following this process correctly helps ensure optimal print quality.

Capsule Components

A Multi Unit Capsule consists of the following key parts:

• White plunger 
• Black plunger 
• Capsule glass (bottom window)
• Red priming clip (used during manual priming)
• Safety film (protective layer on capsule glass)
   

How to Prime a Midas Multi Unit Capsule

1. Start the Print Setup

1. Select your print job and confirm settings by clicking Prepare Print.
2. Scan the capsule QR code.
3. Select Prime this Capsule.

2. Automated Pre-Priming (On Printer)

1. Place the capsule on the printer with the safety film still attached.
2. Ensure the capsule is fully seated on the print glass.

Note: If the Start button is not selectable, press the capsule down gently until it is properly detected.

3. Select Start.
4. The Midas arm will begin pre-priming by slowly moving the capsule piston downward.

Once complete, remove the capsule and select Next.

3. Manual Priming (Using Red Clip)

1. Place the capsule on a flat surface.
2. Ensure the red priming clip is still attached to the white plunger.
3. Using both hands:
   • Press the white plunger downward against the red clip
   • Then alternate pressing the white and black plungers
4. Repeat this full motion 10 times to thoroughly mix the resin.

4. Final Position Check

1. Press the black plunger fully down to its lowest position.
2. Select Next on the touchscreen.

5. Final Preparation

1. Remove the red priming clip.
2. Select Next.
3. Remove the UV safety film from the bottom of the capsule.
4. Place the capsule back onto the printer.