Cleaning The Build Platform

Always check the build platform before you begin a print to make sure it is clean. Small pieces of cured resin that remains stuck to the platform can cause a failed print. Follow a simple cleaning method before each print to ensure that your models look great every time.

platform-prepare.jpg


Procedure

Begin by removing the build platform from the arm by rotating the black rudder counter-clockwise. Slide the platform toward you until it is fully removed from the arm.

platform-remove.jpg

Use a spatula or finishing tool to gently scrape off any excess cured resin that is stuck to the platform. To be sure you’ve removed all excess resin, use isopropyl alcohol and a paper towel or soft cloth to wipe down the surface of the build platform.

platform-wipe.jpgplatform-clean.jpg

Slide the build platform back onto the arm and rotate the rudder clockwise until it sits snugly.

platform-return.jpg
Was this article helpful?
2 out of 8 found this helpful