Cleaning SprintRay Pro Build Platform

Remove the build platform

To remove the build platform, turn the red knob to the 'unlock' position, then pull the plate toward you until it slides fully off of the build arm.

ezgif.com-video-to-gif__5_.gif

Remove cured resin

Use the provided print removal tool to scrape off any excess bits of uncured resin from the build platform, careful not to gouge the printing surface. To avoid gouging, slide the print removal tool at a steep angle along the surface of the platform.

mceclip5.pngmceclip0.png

ezgif.com-gif-maker__1_.gif

Wipe down with IPA

Spray IPA 91% or greater on the build platform, fully saturating the surface. Wait for a few moments to ensure that the IPA has time to break down cured resin. Use a paper towel to wipe away the IPA. Repeat if necessary until platform is clean.

ezgif.com-gif-maker__2_.gif

mceclip1.png

We can help with that!

If you're experiencing difficulties or have questions about any of your SprintRay products, submit a support ticket or contact us at 800-914-8004

Was this article helpful?
1 out of 2 found this helpful